水草情迷

Thank you for your comments. Of course I will keep trying and hopefully you guys may find usefull in future.

Hi Andrew,

恭喜哂! 你的diy HQI 真的很正. 跟手就要考慮一下遮光問題啦!
還記得我嗎?

I never agree people DIY electric item for aquarium. BTW, this time, I could say nothing but good............I believe Andrew "Hing" have some basic concept in electric field , by such prof. & beautiful outlook, I may dare to say this DIY HQI must be safety than some aquarium HQI set from China. Anyway, Andrew "Hing"---Is it possible to expose more details of this DIY HQI to the fish friend here ???(Such as where to buy the parts , dimension, drawing lay-out) I would say this is the best DIY HQI I saw..............

Yes I remember you Yip. Actually I made one light which was exactly same as you, but the outlook was too "heavy" since i have two 150W light but you only had one.

Yes for the covering which I haven't finished yet. I was thinking using 0.3mm stainless steel by bending it nicely. Well do you guys have any idea ?

Thank you for Kit's comment. I was bit afraid DIY for such high temperature and high voltage at first since I don't want to burn my house down. So, I did manage to change all the wires in the casing to high temperature wires and cover them all with heat resistance wire tunnel. Of course cooling fan was used for constant air flow for both the light and the transformer.

Sure no problem, but all my drawings were in hand written. If you are interested just email me and I will fax to you.

Andrew:

Could you please FAX the drawing to the following fax number?

2877-0017

Thanks

OK

200 for a HQI is really cheap! i found a set HQI with Phlip transformer, super white Osram 150W and china case in PRC cost RMB338. Could u let me know if it is the same make up.

Andrew:

Could you send your email address to my email account [email protected] ?

Thanks!

Hello Andrew, Can I also have a copy of your drawing and instruction ? Thanks a lot?

email: [email protected]
FAX: 2243-8760 (att: Ben Ho)

Hi Andrew,
Can you please show me the drawing and instruction of your HQI.
well, I was planning to purchase one, however, it is reaaally expensive (especially in Canada). i couldn't afford it.(still a poor student), and i just found this page recently that inspired me to make one!!!
my email address is [email protected]

thank you very much

Beefeater

Could you please FAX the drawing to the following fax number?

fax no.25779976

Thank you very much

next

Andrew兄,如沒有車牀,在那裡有現成的铝金屬配件買?裁牀機器一定非常昂貴?

Very nice
Due to hot air is rise up, The fans are install in the top of the case is much better
Now, You can drill the some holes on the top plate. I think it can improved more.

正!!!!!正!!!!!!!!!如果可以Post成張圖去精華區就完美!!