水草情迷

夠la
我都係咁

After testing the chiller for 2 days, I have the following questions want to ask:

1. Why there is so many water drops on the surface outside of the tank? (I believe because of the temperature difference between the room temperature and the water temperature inside). How to avoid this? How serious is that? Can you post a photo?
2. What is the normal temperture set as default in chiller in summer? Now, I set 24 degree, is it ok? The calibration of each device maybe different. You should check the temperature of the tank. As long as it is at 24c or below, it should be fine.

Thanks.

After testing the chiller for 2 days, I have the following questions want to ask:

1. Why there is so many water drops on the surface outside of the tank? (I believe because of the temperture difference between the room temperature and the water temperature inside). How to avoid this?
可以用風扇吹住個缸.
2. What is the normal temperture set as default in chiller in summer? Now, I set 24 degree, is it ok?

Thanks.

zetahalflife: 24W each tube. BTW, I'm curious about how you connect the chiller. Is it "Inlet->Canister->Chiller->Outlet"? 'cos I doubt if a 2215 can do that. I'm using a 2224 and have it connected to an UV. The flowrate is just marginal.

Thanks for your comment, is it the problem of the air flow in the room?

zetahalflife: Yes, this is what I meant. I look forward to your report then. I have been thinking of having a chiller but I'm afraid that the 2224 is not strong enough to push. I don't want to buy a 2028 for that purpose. Meanwhile, I'm just using cross-flow fans to do the cooling job.