水草情迷

小弟新開缸一個星期多, 用 ADA II 黑泥, 沿有舊缸之水及濾筒(濾筒約一年未洗, 內有黑色生化棉, 3格生物環, 頂層白棉), 新加約 1/5水, 另加入新草及3條工作魚. 一開始水已很清, 水溫 26度, 水草有出新葉及出泡, 魚仔冇事, 正常過度新環境, 期間有加水草及將水草移位.

但前日發覺水開始唔清, 有少少白, 但不是十分嚴重, 於是換水 1/5, 但昨晚睇過情況依舊, 於是清洗濾筒一次, 換入新白棉, 其他濾材冇換, 今早睇都仍然有少許白, 不知問題出於那裡

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

Something's wrong with the purifying bacteria... what else have you done?

_________________
24"x12"x14" w/ Eheim 2026+Arctica Mini
GLO T5HO 24Wx2
Lighting: 12:00pm-9:00pm
CO2: 2+ bubbles/sec
ADA Amazonia New

冇搞過特別野, 剩係加草 & 搬草

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

Have you checked the bio-rings? Are they clogged? If they're clogged, there's a chance that the purifying bacteria cannot survive. BTW, how do you wash the canister? When you move the plants, is there any dirt being pulled out from the soil layer?

_________________
24"x12"x14" w/ Eheim 2026+Arctica Mini
GLO T5HO 24Wx2
Lighting: 12:00pm-9:00pm
CO2: 2+ bubbles/sec
ADA Amazonia New

前晚來個大清洗, 先將生物環用魚缸舊水浸洗, 換掉白棉, 用清水洗淨生物棉及濾筒, 加多一包新既生物環. 見到舊既生物環及濾筒都幾污濁, 請問生物環幾耐要換一次?

插草及移草已經很輕手, 只有很少量沙泥升起.

今早魚缸水仍然有少少白, 缸邊玻璃有白色水印, 已暫停餵魚兩天.

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

I rinse the bio-rings when I wash the canister, usually 1-2 months. If the milky water persists, you may try the following:
1. Add 硝化细菌 whenever you change the water
2. Turn on your air pump in the midnight when your light is off
3. Try to keep the water at around 28c during the midnight. But you have to be careful. Once your water is clear, resume everything to normal. High temperature can kill plants.

_________________
24"x12"x14" w/ Eheim 2026+Arctica Mini
GLO T5HO 24Wx2
Lighting: 12:00pm-9:00pm
CO2: 2+ bubbles/sec
ADA Amazonia New

(前晚來個大清洗, 先將生物環用魚缸舊水浸洗)
生物環五洗的，洗左会来也。

想試下用 Black Pearl, 唔知有冇 c-hing 用過, 效果如何?

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

過左個幾星期後, 水已變回清澈, 但缸邊都會有白色既水印, 是否正常?

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

Me 2, my new tank (400L water) also needs 2 wk to become clear. You can use toothbrush to clean 缸邊白色既水印...don't worry.

問題係...當魚缸水慢慢蒸發後, 缸邊會留下白色水印, 要時常擦, 我想知係咪正常, 定係我本身個過濾唔夠 ?

_________________
KOTOBUKI F-600S
(W600×D300×H360)（57L）
Atman CF-1200
Mr.Aqua CO2

Yes, I think so, 水印正常! More 水印 at the beginning (cloudy water) and become less later. 蒸發後 U can water back than 水印 disappear.